Locksmith Palmers Green Lock Change Replacement Key Cutting
Vehicle Locksmith Palmers Green, Cheap Door Locks, Door Handles Knobs Repaired, Security Locks, Patio Door Lock Repair, Lock Out 24 7 Emergency Service.
Please Use The Contact Form Below With Any Questions Or Requests. Wherever you are in the UK We Can Help.
Locksmith Near Me
Door Lock
Door Knobs
Combination Door Knob Locks
Patio Doors Locks
|
Just wondering you lokies at the locksmith Palmers Green if the alpro fixing kit can be used on Union L222070 Euro sashlock cases fixing to alu door or are there dedicated fixing tabs to be had. With Union locks if you have a look at their website or others you can normally find a pdf with measurements on it then just compare with what you have from those I've taken out in the past I've just replaced like for like and there wasn’t any special fixings.
These locks go on the UPVC and aluminium doors there are 2 metal tabs that secure the case into the lock slot. Was just wondering if these are still available. A quick question for you. I have recently had a couple of mortice locks to open and not had any joy in identifying them. Both were curtain locks and all I could see was rusted keyways. I have my ID manual from my course from 1st call lockouts but even with the handle set removed I just can't even see the case colour for a start, and was unable to find any other marks, hard plates to assist in the ID. On the left mounted lock I had to drill a hole 18mm up and 5mm towards the bolt as suggested in the manual and was able to see the levers and get the lock open.
Now for the right mounted lock, again no ID was possible as all the lock I could see was so corroded and it was just after 1am and lighting was bad. I have drilled locks on the bench through the bolt and some went well, some didn't so I did not fancy doing that at that time in the morning. Now I did manage to gain entry via other means, but that’s another long story! My question is has anyone got any tips on lock ID? Living on the coast it seems as though every mortice lock I come across, no matter how old or new, they are so corroded that i just cannot get an ID. Well locksmith Palmers Green I did try just going through the logical steps of a normal pick but just could not get the buggers to go. I do not have any decoders as of yet so even with an ID on the lock it’s not really much of an advantage other than knowing the correct NDE drill points. NDE and drill points don’t go together. Look at the gauge of the curtain. Turn it with a cut down key to see where it goes to. Look at the hard plate, is it a glove fit, can’t see one it may be above the key way. it it closed or open, what is the shape of the curtain, ie is it tapered, legge does it have a nick in the 12 o/c position.
There are loads of other methods mate. By throwing the lock into anti pick you will know what anti picks it has, ie square gate, v gate or no anti picks. You can get a chisel and shave at an angle to see the colour. Once you get confident with curtain picking you do not need to id a lock as locksmith Palmers Green boys said have a feel about in the lock to see what levers are in there once you know what type of levers are in there use that procedure for that lever type hope this helps. |
Key Cutting
Furniture Locks
24 Hour Locksmith
Door Handles
Padlock
|
|
|
Thanks For Visiting Our Locksmith Palmers Green Shop
| Home | Back To Top | Services | About | Contact | Terms | Privacy | Cookies | Locked Out |
| Home | Back To Top | Services | About | Contact | Terms | Privacy | Cookies | Locked Out |